October 26, 2012
Dear Reactis User:
Reactis V2012.0.2 and V2011.2.6 are now available.
Reactis V2012.0.2
The following bugs were fixed since V2012.0.1:
- Fixed bug where GUI crashes when clicking on output line of unresolved
reference block (#2271).
- Fixed issue where GUI dialogs get distorted after loading a model containing
a large number of annotations (#2282).
- Resolved problem causing "Error: Bad value for input..." messages when
attempting to control fixed-point inputs in user-guided simulation (#2280).
- Fixed issue where Tester in some cases generated inputs that were slightly
different from the allowed values for an input configured with a "step" type (#2266).
- Fixed "Error: Cannot convert '{...}' to 'double' value" that could occur
during "Fast run with report" for models containing bus-typed outports (#2262).
- Fixed inefficiency that caused Reactis to appear to hang during initialization
if a model contained Stateflow charts with long paths of control logic ending
in a state (#2259).
Reactis V2011.2.6
The following bugs were fixed since V2011.2.5:
- Fixed bug where GUI crashes when clicking on output line of unresolved
reference block (#2272).
- Fixed issue where GUI dialogs get distorted after loading a model containing
a large number of annotations (#2283).
- Resolved problem causing "Error: Bad value for input..." messages when
attempting to control fixed-point inputs in user-guided simulation (#2281).
- Fixed inefficiency that caused Reactis to appear to hang during initialization
if a model contained Stateflow charts with long paths of control logic ending
in a state (#2260).
You may download the patches or full installers from the
Reactis User Pages.
Best Regards,
The Reactis Team