August 20, 2012
Dear Reactis User:
Reactis V2012.0.1 and V2011.2.5 are now available.
Reactis V2012.0.1
The following bugs were fixed since V2012:
- Fixed "Error: Signal not found in bus" messages that could occur if the "Bus
element name visibility" setting (in Edit->General) was set to "Show element names
for all buses" (#2250).
- Resolved problem where "edge" output triggers from Stateflow chart were not
properly buffered when multiple triggers occurred within the same time step (#2253).
- Fixed "Invalid 'case condition' expression" error that would occur if a "newline"
character was used in the 'Case Conditions' expression of a "Switch Case" block (#2242).
- Fixed bug where "Simplest" rounding mode setting would incorrectly be reported
as not supported for "Multi-Port Switch" blocks (#2246).
- Resolved issue where Reactis would in some cases infer the wrong data type for
a DWork vector in an S-Function (#2244).
- Fixed "Bug: invalid cast" that could occur when filtering an element of a bus
in a test suite using the "." notation (#2202).
- Fixed minor issue in Japanese GUI translations (#2252).
Reactis V2011.2.5
The following bugs were fixed since V2011.2.4:
- Resolved problem where "edge" output triggers from Stateflow chart were not
properly buffered when multiple triggers occurred within the same time step (#2254).
- Fixed "Invalid 'case condition' expression" error that would occur if a "newline"
character was used in the 'Case Conditions' expression of a "Switch Case" block (#2243).
- Fixed bug where "Simplest" rounding mode setting would incorrectly be reported
as not supported for "Multi-Port Switch" blocks (#2247).
- Resolved issue where Reactis would in some cases infer the wrong data type for
a DWork vector in an S-Function (#2245).
You may download the patches or full installers from the
Reactis User Pages.
Best Regards,
The Reactis Team